Southern Buttermilk Biscuit Recipe
 |
| Photos courtesy of Cecil Nye |
Recipe & Photos submitted by Cecil Nye
More of Cecil’s recipes can be found at the Iron Cooker website
Ingredients
2 cups unbleached all-purpose flour, plus more for dusting the board ( if you can get White Lily flour, your biscuits will be even better)
1/4 teaspoon baking soda
1 tablespoon baking powder ( use one without aluminum)
1 teaspoon kosher salt or 1 teaspoon salt
6 tablespoons unsalted butter, very cold
1 cup buttermilk ( approx)
Directions
Preheat your oven to 450°F.
Combine the dry ingredients in a bowl, or in the bowl of a food processor.
Cut the butter into chunks and cut into the flour until it resembles course meal.
If using a food processor, just pulse a few times until this consistency is achieved.
Add the buttermilk and mix JUST until combined.
If it appears on the dry side, add a bit more buttermilk. It should be very wet.
Turn the dough out onto a floured board.
Gently, gently PAT (do NOT roll with a rolling pin) the dough out until it’s about 1/2″ thick. Fold the dough about 5 times, gently press the dough down to a 1 inch thick.
Use a round cutter to cut into rounds.
You can gently knead the scraps together and make a few more, but they will not be anywhere near as good as the first ones.
Place the biscuits on a cookie sheet- if you like soft sides, put them touching each other.
If you like”crusty” sides, put them about 1 inch apart- these will not rise as high as the biscuits put close together.
Bake for about 10-12 minutes- the biscuits will be a beautiful light golden brown on top and bottom.
Do not over bake.
Note: The key to real biscuits is not in the ingredients, but in the handling of the dough.
The dough must be handled as little as possible or you will have tough biscuits.
I have found that a food processor produces superior biscuits, because the ingredients stay colder and there’s less chance of over mixing.
You also must pat the dough out with your hands, lightly.
Original submission 3/2015
